How To Install A New S Trap Toilet Installation

All toilet bowls have integral p traps to keep sewer gases out. Compaq Desktop Presario Drivers there. So this should just be a normal toilet bowl installation. Alkitab Elektronik Untuk Windows Xp here. Here, the closet flange is a pipe in the floor with a flange that accepts johhni bolts (either 1/4' or 5/16' johhni bolts available as well as long shank type. I use 5/16' most of the time). The closet flange should set on top of the floor.not flush, but on top (if it is not it should be extended using an extension kit or by cutting the pipe and using a coupling and new flange to set flange on top of ceramic tile.then using a 1/4' carbide drill bit you can install/secure the flange through the holes in flange through tile using 1/4' plastic cement anchors and screws).

Then, you would insert (actually slide) the johnni bolts into the channels on the sides of the flange (center these to the flange), you would install a wax gasket (most install on the bottom of the bowl (around raised hole) and set the bowl squarely down over the johhni bolts. Use your body weight to slowly push down on toilet ( a big mistake beginners make is to let the bowl drop in front or in back while setting toilet bowl. Do not do that.

Roland Dyens Night And Day Rare. Push down with equal pressure. Attach the finish cap plastic washer and the metal washer supplied with the johhni bolts and then the nuts over the johhni bolts. Tighten down.

A little at a time on both sides. Square the toilet to the wall. Tighten a little more. Check if bowl rotates. Take time and do not overtighten. Heck, since you live there if you are unsure at all, tighten until you are unsure then wait for awhile. Let wax spread a little and then recheck tightness.

It's just a judgement call really. Anyway, as long as it does not seem loose. You will be fine. Then install the toilet tank, etc.